Relais instantanés et de Fonction
Imprimir
CARA
Description
Fast action instantaneous relay.
Relay housed in a rectangular enclosure and pluggable on socket including a locking bracket and two guide pins which can act as a key to ensure that the correct relay is used at the correct voltage (see our withdrawal guide in the technical support pages of this site)
Pluggable on the following sockets : EVB1/CA, ERDL1/CA, ERDL1/CA-DL et ERC1/CA.
Relay housed in a rectangular enclosure and pluggable on socket including a locking bracket and two guide pins which can act as a key to ensure that the correct relay is used at the correct voltage (see our withdrawal guide in the technical support pages of this site)
Pluggable on the following sockets : EVB1/CA, ERDL1/CA, ERDL1/CA-DL et ERC1/CA.
Encombrement
Raccordement
Principe de fonctionnement
Fast action relay which can be turned on permanent voltage :
* minimum impulse duration : >= 30 ms
* recycling time >= 300 ms
Operating position : spring set on the top and vertical coil axle
See the operation diagram hereafter.
* minimum impulse duration : >= 30 ms
* recycling time >= 300 ms
Operating position : spring set on the top and vertical coil axle
See the operation diagram hereafter.
Caractéristiques
| Fonction | Instantaneous |
| Présentation | under cover |
| Raccordement | on front or rear wiring socket |
| Nombre de manoeuvres mécaniques | 5.000.000 |
| Température de fonctionnement | - 5°C to + 40°C |
| Température de stockage | - 40 to + 70°C |
| Catégorie climatique | optional reinforced climatic protection |
| Tension de choc | 5 KV (wave 1,2/50 µs) |
| Rigidité diélectrique | 2200 V eff 50 Hz |
| Résistance d'isolement | NFC 45-202 : C250 ; VDE0100 : C250 |
| Masa | 300 g. |
| Degré de protection | IP 40 (according to NFC 20-010) |
| Tenue aux chocs mécaniques | severity 50 A (according to NFC 20-608) |
| Tenue aux vibrations | 0,35 mm / 10-55 Hz (according to NFC 20-616) |
Bobine
| Courant continu | Courant alternatif | ||
| Tension nominale mini. | 24 V | ||
| Tension nominale maxi. | 220 V | ||
| Domaine d'action | -20/+10% of nominal voltage | ||
| Classe de puissance | operate : < 50 W - hold : < 3 W | ||
Contactos
| Número de contactos | 4 |
| Courant permanent maxi. admissible | 8 A per contact |
Diagramme de fonctionnement
see operating description here above
Document non-contractuel - Caractéristiques à se faire confirmer avant commande
Tec automatismes se réserve le droit de modifier les descriptions et spécifications sans préavis
TEC Automatismes © 2024, Tous droits réservés